Configure The Psf Printer In Jes2 Or Jes3 - Xerox DocuColor 2060 Installation Planning Manual

Configuring in
JES2
Item
description Default
FSS parameters
PROC None
AUTOSTOP NO
Installation Planning Guide
Defining the printer to the host: TCP/IP attachment

3. Configure the PSF printer in JES2 or JES3

This section discusses the procedures for configuring the printer
in JES2 or JES3 environments.
To configure the PSF printer in JES2, follow these steps:
1. Locate the JES2 initialization dataset in the JES2 Startup
JCL Procedure (JES2 PROC). (This is normally kept in
SYS1.PROCLIB, although your system may use a different
library.)
The JES2 PROC has a DD statement (normally
HASPPARM), which points to the initialization dataset. (The
location of this statement is SYS1.PARMLIB(JES2PARM);
however, you should always verify the location on your own
system.)
2. Enter the following required commands in the JES2
initialization dataset to define the PSF functional subsystem
(FSS):
• One FSS statement for each PSF functional subsystem
• One PRTnnnn statement for each functional subsystem
application (FSA) under control of the FSS. (This can also
be specified as PRINTnn or PRINTERn.)
The following table lists the JES2 FSS statement parameters
to be defined.
Table F-1. JES2 FSS statement parameters
Range of
Source of acceptable
value values
PSF Startup 1 to 8-character
procedure alphanumeric
name/ string
Installation YES or NO
preferences
Comments
Specifies name of
procedure for starting
this FSS. Different
FSS statements can
refer to the same
startup procedure
Specifies whether FSS
address space is
stopped automatically
if all FSAs under
control of the FSS are
stopped.
Your
value
F-3