Space Requirements - Xerox 4850 Installation Planning Manual

Condition
4890/92C Printer–60 Hz heat dissipation:
4890/92C Printer –50 Hz DELTA heat
dissipation:

Space requirements

Installation Planning Guide
Table 6-8. Environmental specifications for 4850/4890/92C
You should consider the following factors when deciding where to
place the printer hardware components:
• Adequate work space and service clearance around the
equipment
• Proximity to electrical and network connectors
• Security of the work area. You may need to place the system
in an area where you can restrict access to it. This may be
important if your personnel need to print confidential
documents or if you are concerned with unauthorized usage.
Dimensions and weights of the printer components are listed in
this section, along with diagrams, to help you visualize the sizes
and total space requirements.
The printer controller must be positioned within the line-of-
sight of the printer for safety purposes while servicing the
equipment.
NOTE: There must be a 78-inch / 198-cm vertical clearance
throughout the entire area. In addition, your printer must be
installed in a fixed location with a minimum clearance space of
36 inches / 91.4 cm around all sides of each piece of equipment
for access by service personnel.
For information on clearance space and other space planning
considerations, refer to the "Space planning guidelines" section
of this chapter. Contact your service representative if you have
questions not specifically addressed in this guide.
Printer specifications and requirements
Range
Operating: 14,980 BTU/hour
Standby: 9,100 BTU/hour
Operating: 14,980 BTU/hour
Standby: 9,100 BTU/hour
WARNING
6-5