Xerox 4850 Installation Planning Manual page 182

Defining the printer to the host: TCP/IP attachment
Table F-3. JES3 FSS statement parameters (Continued)
Item
description Default
WC Any class
selected
WS
FSSDEF TYPE=WTR,FSSNAME=FSSTCP1,PNAME=FSSPROC1,SYSTEM=SYS1,TERM=NO
DEVICE DTYPE=PRTAFT1,JNAME=PRT7,JUNIT=(,SYS1,,OFF),FSSNAME=FSSTCP1,
DGROUP=LOCAK, MODE=FSS,PM=(LINE,PAGE,SOSI1),WC=(T),WS=CL,D,F)
F-8
Range of
Source of acceptable
value values
Installation List of
output class alphanumeric
standards output classes,
each separated
by a comma
Installation Work-selection
preferences criterion
(see note)
NOTE: The WS parameter CL specifies that datasets with
the same class as the WS parameter should be selected. D
specifies that only datasets with the same destination as the
DGROUP parameter should be selected. F specifies that
JES3 is to pass the forms value specified on the DD or
OUTPUT JCL statement to the FSA.
Following is an example of the JES3 initialization dataset
required commands:
Table F-4. JES3 initialization dataset commands example
Comments
If CLASS is specified in
the Work-selection
criterion in the WS
parameter, the FSA
selects datasets that
match values specified
here.
Consider CL, R, and F.
See Note below and
JES3 Initialization and
Tuning Reference
manual for more
information.
Installation Planning Guide
Your
value