Xerox 4850 Installation Planning Manual page 186

Defining the printer to the host: TCP/IP attachment
Table F-5. PSF/MVS PRINTDEV statement parameters (Continued)
Item
description Default
SETUP No Setup
message
s issued
RELINTV
RELMODE None
TIMEOUT
TRACE NO
F-12
Range of
Source of acceptable
value values
Installation SETUP=FORMS
preferences if specified
IDLE, TIME, or
NONE
Installation REDRIVE or
preferences STOP
YES or NO
NOTE: To specify a TCP/IP address space name other than
the default (TCPIP), code the following EXEC statement in
the appropriate PSF writer procedure:
STEP01 EXEC PGM=APSPPIEP,
PARM=(,,,,tcpip_name), REGION=4096K
where tcpip_name is the name of the TCP/IP address space.
Comments
If specified, causes JES
to issue FORMS setup
message when a job
prints which has a
FORMS specification
different from job
previously printed. This is
recommended where
there are multiple paper
stocks for use on the
printer.
Not applicable to Xerox
cut-sheet printers
Not applicable to Xerox
cut-sheet printers
REDRIVE: When there is
a time-out after period
specified in DISCINTV
parameter, REDRIVE
requests that PSF
attempt to drive the
printer according to
MGMTMODE
specification.
STOP: Forces operator
to restart FSA.
Note: REDRIVE is
recommended for TCP/IP
printers that may be
shared with other hosts.
Should be used only for
debugging PSF-related
problems.
Installation Planning Guide
Your
value