Other Supplies; Dry Ink; Fuser Lubricant; Developer - Xerox 4850 Installation Planning Manual

Supplies

Other supplies

Dry ink

Fuser lubricant

Developer

A-6
This section describes the supplies other than paper that are
necessary for installation and afterward. Your sales
representative will help you place your initial supply order.
Dry ink (also called toner) is the black powder which forms the
image on the printed page. There are three cartridges of dry ink
in each carton. You should keep at least one extra cartridge on
hand at all times. The disposable cartridges are easily changed
with no mess. The consumption rate of Xerox dry ink is
approximately one cartridge per 30,000 pages. Use only dry ink
that is specified for use in the 4850/4890/92C printer, as
described in the consumable supplies table.
Fuser lubricant is a consumable item required by the printer. You
should keep at least two boxes (each box contains two tubes) on
hand for installation by the service representative. The
consumption rate of Xerox fuser lubricant is approximately one
tube per 120,000 pages. For product information, refer to the
consumable supplies table in this appendix.
Developer is not consumed by the printer but does have an
effective life of approximately 300,000 pages per bottle,
guaranteed by Xerox. Developer is a required item and must be
kept on hand.
Use only the developer specified for use in your 4850/4890/92C
printer.
For colored inks, use the color developer specified for each color
in the table below:
Installation Planning Guide