Installation Planning Checklist - Xerox 4850 Installation Planning Manual

Preparing for installation

Installation planning checklist

4-4
– Have the required parameters defined for configuring PSF
to print on the NPS/IPS. Refer to the "Defining the
channel attached printer to the host" or the "Defining the
printer to the host: TCP/IP attachment" appendix of this
guide for examples and explanations of these parameters.
• Client workstations: Make sure all client workstations that
will be submitting print jobs have the proper hardware,
operating system, and networking software supported by the
DocuPrint system as client platforms.
• Training
– Select the personnel to undergo operator training.
– Set up the operator training schedules.
• Applications
– Work with your Xerox system analyst to determine
requirements for the initial applications.
– In a mixed environment, where there is a variety of
printing systems, discuss print quality differences with
your service representative.
Make sure that your system specialists are familiar with the
software specific to your printer; system software is not the same
for all laser printing systems. If your system specialists are
familiar with one of these operating systems and you are
converting to or adding another, they should be aware of the
differences.
To aid you in installation planning of the DocuPrint NPS/IPS, this
section provides a checklist, listing tasks you and your service
representative need to complete in the weeks before installation.
If you have questions about any of these activities, contact your
sales or service representative.
Installation Planning Guide