HCU placement
(channel-attached
systems only)
Installation Planning Guide
The following illustration shows fan and vent locations on the
front and back of the controller.
Figure 5-4. Sun Ultra 60 fan and vent locations to keep clear
1. Vent in front of processor
2. Fan in back of processor
3. Vent in back of processor
Do not:
•
Do not place the controller monitor on top of the processor.
•
Do not allow any piece of equipment to blow warm air into the
air intake vents of the processor.
•
Do not place the processor on its side, or in any other
position but the upright, vertical position shown in the
previous figure.
•
Do not place the processor or monitor on top of the printer.
The following shows the recommended HCU hardware
placement, for channel-attached systems that do not use the
Groupe Set board.
Controller specifications and requirements
5-7