Xerox 4850 Installation Planning Manual page 88

Controller specifications and requirements
Table 5-4. DocuPrint NPS/IPS printer controller specifications and power requirements:
Dimensions (depth,
Device width, height)
Processor d=17.5 in. / 44.5 cm
w=17.5 in. / 44.5 cm
h= 5 in. / 12.7 cm
Monitor d=21 in. / 53.3 cm
w=19 in. / 48.3 cm
h=21 in. / 53.3 cm
4 mm cartridge d=12.25 in. / 31 cm
tape drive
w=7.5 in. / 19 cm
h=2.75 in. / 7 cm
Keyboard d=7.5 in. / 19.1 cm
w=20 in. / 50.8 cm
Mouse d=3 in. / 8 cm
w=4 in. / 10 cm
h=2 in. / 5 cm
Host Channel d=15 in. / 40.8 cm
Unit (HCU)
w= 16 in. / 41.6 cm
(channel-
attached
h=5 in. / 12.6 cm
systems only)
Channel d=9.7 in. / 24.6 cm
interface
w= 27.1 in. / 68.8 cm
board and
channel cable
connector box
(channel
attached
systems only)
5-10
Sun Ultra 60
Heat
Weight dissipation Power requirements
27 lbs. / 1,100 BTU 60 Hz:
12.7 kgs per hours 100 to 240 VAC,
15 amp, 0.4 KVA,
5-15 NEMA
50 Hz:
100 to 240 VAC,
15 amp, 0.4 KVA
61 lbs. / 408 BTU 100-120 ~ VAC,
27.7 kg per hour 1 phase, 50-60 Hz,
3.0 amp, 0.4 KVA
200-240 ~ VAC,
1 phase, 50-60 Hz,
2.0 amp, 0.4 KVA
8 lbs. / --- 100-120/200-240 VAC,
0.8/0.4 amp, 47-63 Hz
6.6 kg
2 lbs. / --- ---
1kg
0.3 lbs. / --- ---
0.14 kg
26 lbs. --- 120 VAC within 6 feet;
10 oz. / 120 volt at 2 amps or
12.4 kgs 240 volt at 1 amp
--- --- 100 to 240 VAC,
15 amp, 0.4 KVA
Cable lengths
Power: 8 ft. /
2.4 m
Interface to
printer:
20 ft. / 6.1 m
usable length
Video cable to
processor:
46 in. / 1.17 m
SCSI cable to
processor or
additional SCSI
device:
28 in. / 71 cm
72 in. / 1.8 m
25 in. / 63 cm
Bus and tag
cables must
conform to host
system
requirements
(200 gray cable
to 400 ft. blue
cable / 66.7 to
133.3 m) and
accommodate
system setup.
Cable from board
to box: 3 ft / 91.5
cm
Installation Planning Guide