Xerox 4850 Installation Planning Manual page 65

Installation Planning Guide
• Overseeing routine maintenance
• Placing service calls for hardware problems
• Ordering additional documentation, software, or fonts
• Arranging additional operator training
• Maintaining an adequate inventory of consumable
supplies.
It is your responsibility to designate a person (or persons)
to perform these tasks.
• Operator and Administrator training
– Select personnel for Operator and Administrator training.
– Set up a training schedule.
• Site preparation
– Select and prepare the site for DocuPrint NPS/IPS system
installation including proper power, air conditioning, and
work space.
– Plan and schedule installation activities.
– For channel-attached systems: Provide your host channel
address to your Xerox representative.
– Install the necessary network connections required to
connect client workstations to the printer controller. Refer
to the "Network preinstallation checklist" in this chapter.
– Install Ethernet or Token Ring to system location.
– Obtain the necessary interfaces, cables, transceivers, etc.
NOTE: You are responsible for obtaining, stringing, and
maintaining fully-populated bus and tag cables for
channel-attached systems.
– Sysgen your host to print to an AFP Type1, Group 3
printer. Refer to your IBM documentation for further
information.
– For stitcher/stacker option: Work with your service
representative to determine the "low wire" percent values
to be displayed on the printer control console.
– Provide a list of the stocks you want in your default input
tray configuration.
– Review the NPS/IPS Installation Planning Guide
thoroughly.
Preparing for installation
4-3