Table of Contents
Advertisement
BOOK TOC
CHAPTER TOC
SEARCH
USB Cable
Your Xerox WorkCentre is equipped with a USB interface port, that can be
used if you are running windows 98/2000 or Windows NT4.0. However, the
USB cable is not provided with the machine.
Note: If using a USB cable, the parallel cable is not used. In addition, the
computer and the 490cx must be powered on before connecting the USB
cable to the computer.
To connect the WorkCentre 490cx to a computer using the USB cable,
follow the steps below:
1. Turn on the computer and the 490cx and allow them to power up.
2. Plug the rectangle end of the USB cable into the connector on the back of
the WorkCentre 490cx.
3. Connect the other end of the USB cable to one of the USB ports on your
computer. Refer to your computer documentation for assistance with this
procedure.
PREVIOUS PAGE
SET UP YOUR MACHINE
15
NEXT PAGE
Advertisement
Table of Contents
Troubleshooting
