Table of Contents
Advertisement
BOOK TOC
CHAPTER TOC
SEARCH
To connect the WorkCentre 490cx to a computer using a parallel cable,
follow the steps below:
Caution: Make sure the computer is turned off, and the WorkCentre 490cx
is unplugged from the power outlet.
1. Plug the parallel cable into the connector on the back of the WorkCentre
490cx. Swing the metal clips of the connector inward until they lock firmly
inside the notches on the parallel cable connector.
2. Connect the other end of the cable to the parallel port on your computer.
Refer to your computer documentation for assistance with this procedure.
PREVIOUS PAGE
SET UP YOUR MACHINE
Close Cable
Connector
Locking Clips
NEXT PAGE
14
Advertisement
Table of Contents
Troubleshooting
