Application - HBM T10F Mounting Instructions

7
T10F
1

Application

The T10F Torque Flanges measure static and dynamic torques on stationary
or rotating shafts. Due to their extremely short design they enable very
compact test arrangements to be used. They offer a very wide range of
applications.
In addition to conventional test-rig applications (motor, roller and gear
test-rigs) new solutions for torque measurements partly integrated into the
machines are possible. Here, you benefit from the T10F Torque Flanges'
special characteristics:
Ÿ Extremely short design due to flange measuring-body
Ÿ High permissible dynamic loads
Ÿ High permissible transverse forces and bending moments
Ÿ Very high torsional stiffness
Ÿ No bearings, no slip-rings
Due to their construction without bearings and the non-contact
excitation-voltage and measurement transmission, the torque flanges are
maintenance-free. Thus, frictional or thermal effects on the bearings can be
excluded.
The torque flanges are supplied for nominal torques from 50Nm up to 10kNm.
--1
Depending on the nominal torque, maximum speeds of up to 15,000min are
permissible.
The T10F Torque Flanges are protected from electromagnetic interferences.
They have been tested with regard to EMC according to the relevant
European standards, and carry the CE mark.