Table of Contents
Advertisement
T10F
3.5 Installing the stator
On delivery, the stator has already been installed and is ready for operation.
The antenna segments can be separated from the stator, for example, for
maintenance or to facilitate stator installation.
If your application does not require stator disassembly, proceed as described
in sections 2., 6., 7. and 8..
Fig. 3.4: Antenna-segment screwed connections
1. Slacken and remove the screwed connections (M6) on one antenna
segment. Make sure that the fan
2. Use an appropriate foundation plate to install the stator housing in the
shafting such that there is sufficient possibility for horizontal and vertical
adjustments. Do not yet fasten the screws.
3. Use two hexagon
hexagon nuts (internal thread in the stator in the case of stator B) to
reinstall on the stator the antenna segment that has been removed as
described in 1. Make sure that for a defined transition resistance all
required fan
type lock washers are located under the nuts. Do not yet
-
fasten the screws.
Fan-type lock washer
type lock washers are not lost
-
socket screws, the fan
-
type lock washers and the
-
17
Advertisement
Table of Contents
