Table of Contents
Advertisement
2000 Series
Installation Guide
6.Align the horn by rotating it, if necessary. Torque the carriage door to 20 in.-lbs to secure the
stack.
Figure 28 Installing the CA-30 Stack in a Branson Actuator
Verify that the ring/screw head orientation is as shown below, before installing
stack in the actuator. (Ring not required for some 30K boosters.)
i
i
If ring is not oriented properly, it is possible to damage the converter or
cause actuator failure. (booster must be installed to converter with ring fac-
ing converter)
Stack Assembly
Support
Washer
Screw
100-214-226 Rev. 10
NOTE
Ring must be oriented to face converter
Carriage Door
Carriage
Main Support
Assembly
Assemble the Acoustic Stack
Lockwasher
(4 places)
M3 x 8 screw
(4 places)
Ring
Hex Screw
Contact
Terminal
T-Handle
Wrench
Stack Assembly
Carriage
45
Advertisement
Table of Contents
