Table of Contents
Advertisement
Rack Mount Installation
Rack Mount Installation
If the system is Rack Mounted, you need to order the Rack Mount handle kit. The kit includes two
rack mounting handles and two corner pieces, which support the handles and provide the rack
mount interface.
CAUTION
!
The Rack Mount handle kit does NOT support the power supply in the rack. The weight of the
power supply must be supported by integral brackets of the rack itself.
i
NOTE
i
Do not permanently remove the Cover from the Power Supply because it is required for
proper system cooling.
Step
Order and obtain the Rack Mount kit for your Power Supply. The brackets in the Kit are
1
designed for standard 19-inch rack mounting options.
From the front corners of the Power Supply, remove the Front Corner bezels by removing
2
the two Phillips screws. Save the screws.
Noting that one side of each bracket is countersunk to accept the provided flathead
screws, assemble the Rack Mount Handles as shown in Figure 25 'Detail of Rack Mount
3
Handle Kit Assembly' on page -39. (This shows only the Right bracket and handle; the left
side is a mirror-image.) Tighten the screws securely and so they are flush.
Re-using the screws you removed in Step 2, install the assembled Handle in place of the
4
Front Corner pieces.
5
Save the removed hardware corner pieces.
When you are ready to install the unit, use the hardware from your Rack Mounting system
6
to locate the Power Supply.
38
Procedure
100-214-226 Rev. 10
Advertisement
Table of Contents
