Table of Contents
Advertisement
Handling and Unpacking
Depending on which one of the following options applies to you, unpack the Branson actuator
assembly:
Stand (actuator on a base)
CAUTION
!
Heed the "This End Up" arrows and the "Open Top First" instructions. The packaging is
designed to be removed from the assemblies from an upright orientation only.
Figure 2 Unpacking the Stand (Actuator on a Base); right-side view of Stand
Converter
Booster
Insert
Box
18in.
32-1/2in.
Protective
Box
wood block
for shipping
1.
Move the shipping container close to the intended installation location, leave it on the floor.
2.
Open the top of the box. Remove the insert from the top of the protective box, which may contain
the booster, converter, and the toolkit.
3.
Remove the staples at the bottom of the protective box. Lift the protective box off the pallet.
CAUTION
!
Column and column are under spring tension. Do NOT disassemble the column from the
stand. Always keep the column support clamped together.
i
i
NOTE
When making height adjustments, carefully and slowly release the clamps to control the
motion, and hold the stand to prevent sudden movements or injury.
4
Tool Kit
6-1/2 in.
Actuator
53in.
wood block
for shipping
Spring Swivel
Column
Actuator
Support
Base
100-214-226 Rev. 10
Advertisement
Table of Contents
