Table of Contents
Advertisement
Factory Air
Setup
The following instructions are for setting up the welder with the Leveling Fixture.
Table 7
Rough Alignment
Step
1
Install the converter-booster-horn stack.
Adjust the Leveling screws (in a pattern similar to the one shown in Figure 14)
2
using the Branson T-handle wrench or equivalent. The screws should be close
to, but NOT touching the Actuator Base at this time,
3
Install the part and fixture on the center of the Leveling Fixture.
Roughly align the horn, part, and fixture by manually lowering the horn over the
4
center of the Leveling Fixture.
Figure 15 Screw Installation Pattern
3
1
i
NOTE
i
At this point, make sure the Leveling Screws do not contact the Base Fixture surface.
Table 8
Secure Attachment and Precision Alignment of the Leveling fixture
Step
1
Connect the air supply and set the air gauge to a low working air pressure.
Use the Horn Down function to lower the horn on the part. (If your welder does
2
not provide the Horn Down function, lower the horn manually.) Increase air
pressure to the required working pressure.
Turn each leveling screw (in a pattern similar to the one shown in Figure 14)
3
until the screw contacts the Base Fixture surface.
22
Action
2
4
Action
100-214-226 Rev. 10
Advertisement
Table of Contents
