Table of Contents
Advertisement
Assemble the Acoustic Stack
Assemble the Acoustic Stack
This section describes and indicates the steps for assembling the acoustic stack. The steps are
organized around the 20 kHz, 30 kHz and 40 kHz stack types as listed in the sub paragraphs
below. An illustration for assembling typical 20 kHz stack is shown in
CAUTION
If necessary, secure the largest portion of a square or rectangular horn in a soft jawed (brass
or aluminum) vise. NEVER attempt to assemble or remove a horn by holding the converter
housing or the booster clamp ring in a vise.
CAUTION
Do not use silicone grease with Mylar washers. Use only 1 (one) Mylar washer of the correct
inside and outside diameters at each interface.
Table 13
Tools
Tool
20 kHz Torque Wrench
40 kHz Torque Wrench
15 kHz spanner Wrench
20 kHz Spanner Wrench
30 kHz Spanner Wrench
40 kHz Spanner Wrench
Silicone Grease
40
EDP Number
101-063-617
101-063-618
201-118-034
201-118-019
201-118-033
201-118-024
101-053-002
Figure
26.
100-214-226 Rev. 10
Advertisement
Table of Contents
