Table of Contents
Advertisement
Handling and Unpacking
4.
Cut the packing strap securing the actuator support to the pallet.
CAUTION
!
Column and support are under spring tension. Do NOT disassemble the column from the
stand. Always keep the column support clamped together.
i
NOTE
i
When making height adjustments, carefully and slowly release the clamps to control the
motion, and hold the stand to prevent sudden movements or injury.
5.
Remove the block(s) of wood between the base and the support by slowly loosening the two column
clamps (allowing the stand to rise slightly) and then cutting the shipping tape on the block of wood.
RETIGHTEN THE COLUMN CLAMPS.
6.
Loosen the two hub bolts (for column clamping) on the hub.
7.
Lift the actuator and column from the pallet. Carefully lay the stand on its right side (NOT ON THE
SIDE WITH THE LINEAR ENCODER, if present).
8.
Remove the hub from the pallet and set it aside. Some hubs are bolted to the pallet from the top.
9.
Unpack the converter, booster and toolkit from the insert box. Save the packing material, including
the blocks of wood.
10.
Go to Take Inventory of Small Parts. See Table 2.
Actuator (alone)
The actuator, if shipped alone, is assembled and ready to install.
i
NOTE
i
In a custom installation, the actuator must be mounted on an I-beam or other rigid structure.
The mounting surface must be flat within 0.004 in (0.1mm) Total Indicator Reading, in a
tolerance zone of 16 x 3.5 in (410 x 90 mm).
Move the shipping container close to the intended installation location, leave it on the floor.
1.
Open the top of the cardboard box, remove the insert from the top of the box and set it aside.
2.
The tool kit, mounting bolts, and converter and/or booster are shipped with the actuator but in
separate shipping box(es). Unpack the converter, booster, toolkit and bolts from their packages.
3.
Save the packing material.
i
NOTE
i
The packaging may also include the converter and/or booster, if ordered.
6
100-214-226 Rev. 10
Advertisement
Table of Contents
