Table of Contents
Advertisement
2000 Series
Installation Guide
4.
Cut the two packing straps around the base and pallet. Pry off the two wooden shipping blocks (to
the rear of the base) which prevent the base from sliding on the pallet.
5.
The stand can now be moved into its desired location by sliding it off the pallet. Stands have a lifting
hook for the use of overhead hoists to lift the assembly in place.
6.
Remove the block of wood between the base and the column support by carefully loosening the
two column clamps (allowing the actuator to rise slightly, but not allow sudden movements) and
then cutting the shipping tape on the block of wood. RETIGHTEN THE COLUMN CLAMPS.
7.
Unpack the toolkit from the insert box, and other parts (converter, booster, etc.) that may have
shipped with the stand. Save the packing material.
8.
Go to Take Inventory of Small Parts. See
Stand (actuator on a hub)
Figure 3 Unpacking the Stand (Actuator on a Hub); Hub shown separately
Booster
Insert Box
18in.
Protective
Box
32-1/2in.
Shipping
Strap
CAUTION
Heed the "This End Up" arrows and the "Open Top First" instructions. The packaging is
designed to be removed from the assemblies from an upright orientation only.
1.
Move the shipping container close to the intended installation location, leave it on the floor.
2.
Cut the two vertical packing straps, and open the top of the box. Remove the insert from the top of
the box, which can contain the booster, converter, and the toolkit. Set the insert box aside.
3.
Remove the staples at the bottom of the protective box. Lift the protective box off the pallet. Flatten
the box and lay it next to the pallet (you will lay the stand on it soon).
CAUTION
!
The unit may tip over. Stabilize the stand using the lifting hook or an assistant.
100-214-226 Rev. 10
Table
2.
Converter
Tool Kit
6-1/2in.
Two Hub Bolts
(loosen to remove
Hub from Column using
53 in.
a 5/16" allen wrench)
Block of wood
for shipping
Handling and Unpacking
Note: Hubs may be lag-bolted to the
pallet for shipping purposes.
Hub
(shipped in place
on column, on pallet)
5
Advertisement
Table of Contents
