Table of Contents
Advertisement
2000 Series
Installation Guide
Table 8
Secure Attachment and Precision Alignment of the Leveling fixture
Tighten the locking screws to 50 in-lbs/5.65 newton-meters (in a pattern
4
similar to the one shown in Figure 14). When finished, make sure the Leveling
Fixture is level and secure on the Base Fixture surface.
Complete the Leveling Fixture installation by following the instructions in Sec-
5
tion 3, "Horn, Part and fixture Alignment"
CAUTION
Make sure not to over-tighten the locking screws. Too much torque on the locking screws can
distort the Leveling Fixture. Too little torque can cause the locking screws to loosen from
vibration during a weld operation.
Horn, Part, and Fixture Alignment
Follow the instructions in Table 9 to do a precise alignment of the horn, part, and fixture before
welding parts.
Table 9
Precision Alignment
Step
1
Install the part and fixture on the Leveling Fixture, centered beneath the horn.
2
Place a piece of plain white paper between the horn and the part (Figure 15).
Figure 16 Aligning Horn, Part, and Fixture
100-214-226 Rev. 10
Action
Factory Air
23
Advertisement
Table of Contents
