Table of Contents
Advertisement
Assemble the Acoustic Stack
CAUTION
!
If ring is not oriented properly, it is possible to damage the converter or cause
actuator failure. (booster must be installed to converter with ring facing converter,
refer to Figure 27.)
Install a single Mylar washer (matching the size of the washer to the stud) to
5
each interface.
6
Screw the converter onto the booster.
7
Torque to 185 in-lbs, 21 Nm.
9
Screw the booster onto the horn.
10
Repeat Step 7.
1. Loctite is a registered trademark of Henkel Corporation, U.S.A.
For a 40kHz System
Step
Clean the mating surfaces of the converter, booster, and horn. Remove any
1
foreign material from the threaded holes.
Apply a drop of Loctite® 290 threadlocker (or equivalent) to the studs for the
2
booster and horn.
Install the threaded stud into the top of the booster; torque to 70 in-lbs, 7.9 Nm,
3
and let cure for 30 minutes.
Install the threaded stud into the top of the horn; torque to 70 in-lbs, 7.9 Nm, and
4
let cure for 30 minutes.
Coat each interface surface with a thin film of silicone grease –
5
silicon grease to a threaded stud or tip.
6
Screw the converter to the booster.
7
Torque to 95 in-lbs, 8Nm.
Slide the booster/converter assembly into the adapter sleeve. Screw on the
8
adapter sleeve ring nut and leave loose.
9
Screw the booster onto the horn.
10
Repeat Step 7.
Securely tighten the adapter sleeve ring nut with the spanner wrenches shipped
11
with the sleeve assembly.
42
Action
but do not apply
100-214-226 Rev. 10
Advertisement
Table of Contents
