Table of Contents
Advertisement
Factory Air
3
Place a piece of carbon paper face down on top of the white paper (Figure 15).
4
Set the welder for minimum weld time.
5
Weld the part.
6
Examine the resulting weld footprint on the piece of white paper (Figure 16).
Adjust the Leveling Screws until achieving a precise alignment of the horn, part,
7
fixtures Leveling Fixture. Repeat Steps 2 - 7, if necessary.
Figure 17 Uneven Surface Example
Mounting the Stand (Actuator on Hub-mounted column)
During unpacking, you removed the hub from the column/stand assembly. You must choose a
mounting location for the hub that will support the column and actuator, and provide the hardware
to mount it. Four mounting bolt holes are provided at the corners of the casting, and will accept
your 3/8 inch or M10 hardware. Use flat washers against the metal casting to prevent gouging.
i
NOTE
i
The hub must be installed with its front in the same direction as the front of the actuator. The
column bolts of the hub are found on the rear of the hub. See Figure 11 for mounting details.
24
Uneven surface
needs alignment
Flat surface
no further alignment needed
100-214-226 Rev. 10
Advertisement
Table of Contents
