Setting Device Parameters; List Of Settings - Omron NXR Series User Manual

7 Setting Up IO-Link Master Unit
7-2

Setting Device Parameters

This section describes how to set the device parameters of the IO-Link Master Unit.
7-2-1

List of Settings

The following table shows the setting and description of each IO-Link Master Unit device parameter.
Refer to the description of settings in the reference sections for details on the setting range and de-
fault.
If you change any parameter whose update timing is "After cycling power", transfer the setting to the
IO-Link Master Unit and then cycle the Unit/input power supply to the IO-Link Master Unit to apply the
change.
In the Setting column, Port £ represents port number 1 to 8.
Setting
Port£ Device Verification Setting
Port£ Backup/Restore Setting
Port£ Load Rejection Output Setting
Pin4 Communications Mode Setting
Pin2 Communications Mode Setting
Port£ Pin4 Input Filter Value Setting
Port£ Pin2 Input Filter Value Setting
Device ID
Vendor ID
IO-Link Revision
Port£ Communication Delay Time
Process Data In Length
Process Data Out Length
Port£ Serial Number Configuration
Data
7-4
Description
Set the operation of IO-Link device
verification.
Set whether to back up or restore the
parameter settings of the IO-Link de-
vice, or disable the backup/restore
function.
Set the load rejection output opera-
tion.
Set the communications mode for pin
4.
Set the communications mode for pin
2.
Set the input filter value of digital in-
puts for pin 4.
Set the input filter value of digital in-
puts for pin 2.
Set the device ID of the connected
IO-Link device.
Set the vendor ID of the connected
IO-Link device.
Set the IO-Link revision of the con-
nected IO-Link device.
Set the IO-Link communications de-
lay time.
Set the size of the process input data
from the connected IO-Link device.
Set the size of the process output da-
ta to the connected IO-Link device.
Set the serial number of the connect-
ed IO-Link device.
NXR-series IO-Link Master Unit for EtherCAT User's Manual (W640)
Update
Reference
timing
After cy- 9-8 IO-Link Device Verification
cling on page 9-18
power
9-14 Backing Up and Restoring
IO-Link Device Parameters on
page 9-32
9-5 Load Rejection during
Communications Errors with
Controller on page 9-10
9-3 Communications Mode
Settings on page 9-7
9-6 Digital Input Filter on page
9-12
9-8 IO-Link Device Verification
on page 9-18
9-16 IO-Link Communications
Delay Time Settings on page
9-44
A-1-10 Manufacturer-specific
Object 4 on page A-38
9-8 IO-Link Device Verification
on page 9-18