Omron NXR Series User Manual page 112

5 Installation and Wiring
M12 torque handle
4
Mount the M12 attachment on the M12 screw connector of the I/O cable. After you mount the
M12 attachment, rotate the M12 torque handle in the direction shown in the following figure to
tighten the M12 screw connector to the specified torque.
M12 torque handle
Removal Procedure
Use the following procedures to remove an I/O cable. Turn OFF the Unit/input power supply and out-
put power supply to the IO-Link Master Unit before you remove an I/O cable.
1
Insert the M12 torque handle into the tightening hole of the M12 attachment. When you remove
the connector, place the M12 attachment upside down, that is, in the opposite orientation to
that for tightening.
5-20
Hole of the M12 attachment
M12 screw connector
M12 attachment
NXR-series IO-Link Master Unit for EtherCAT User's Manual (W640)