10-2 Setting IO-Link Devices with the CX-
ConfiguratorFDT
This section describes how to work with the CX-ConfiguratorFDT to set the IO-Link devices connected
to the NXR-series IO-Link Master Unit for EtherCAT.
10-2-1
Overview of the CX-ConfiguratorFDT
The CX-ConfiguratorFDT is an FDT frame application for setting, diagnosing, and maintaining field de-
vices.
You can make parameter settings for the IO-Link devices with the CX-ConfiguratorFDT.
Functions of the CX-ConfiguratorFDT
• After you create a network configuration, you can set the IO-Link device parameters and then store
them in the actual IO-Link devices.
• After you create a network configuration, you can load parameter settings from the actual IO-Link
devices.
• You can save the network configuration and IO-Link device settings that you create in a project file.
Network Configuration
You create the network configuration by registering the path to the IO-Link Master Unit, the IO-Link
Master Unit, and the IO-Link devices for ports of the IO-Link Master Unit from your computer (i.e., with
CX-ConfiguratorFDT).
You create the network configuration by placing the following DTMs (device type managers) in the net-
work configuration.
Information
Communications DTM
Gateway DTM
Device DTM
NXR-series IO-Link Master Unit for EtherCAT User's Manual (W640)
Path from the computer (CX-ConfiguratorFDT) to the IO-Link Master Unit
IO-Link Master Unit
IO-Link device connected to each port on the IO-Link Master Unit
10 Setting Up IO-Link Devices
Description
10
10-3