Setting The Io-Link Device Parameters; Exporting The Created Network Configuration To A File - Omron NXR Series User Manual

10 Setting Up IO-Link Devices
For the above system configuration, use the CX-ConfiguratorFDT to create a network configuration as
shown below.
10-2-7

Setting the IO-Link Device Parameters

Use the following procedure to set the IO-Link device parameters.
1
Create the network configuration and register the IO-Link devices.
2
Double-click or right-click the device DTM for the IO-Link device, and select Configuration.
The Configuration tab page is displayed. In the Configuration tab page, Menu is displayed with
Parameter selected.
3
For the Value field for each IO-Link device in the Configuration tab page, select a candidate
from the drop-down list or enter a value.
10-2-8

Exporting the Created Network Configuration to a File

You can save the network configuration that you created to an XML file.
1
Export to an XML file. The operation differs depending on the version as follows.
• For the CX-ConfiguratorFDT version 3.0 or higher, select Export – Export to XML from
PROJECT.
• For the CX-ConfiguratorFDT version lower than 3.0, select Import/Export – Export from the
File menu.
2
Enter the file name and click the Save button. The network configuration displayed in the cur-
rent Network View is saved to an XML file.
10-10
NXR-series IO-Link Master Unit for EtherCAT User's Manual (W640)