Table of Contents
Advertisement
4. Operation
4.1 Key Functions of Control Panel
[Main Display]
①
①
Use to set the of RPM (200 ~ 2,000 rpm)
②
Use to set time, available range up to 23 hr 59 min or continuous
Use to set temperature (RT ~60 ℃) . Display the set temperature while idle,
③
and actual temperature during operation.
④
Use to display the vacuum pressure for checking the vacuum level
Use to save the set values or recall the saved parameters
⑤
(Saving capacity max. 100 memories).
Use to confirm the parameter setting
⑥
/ Check the preset values during operation
⑦
Use to start or stop operation
⑧
Use to open the device lid. Only activated when the vacuum is released.
Use for (1) manual on/off of vacuum pump. It is only activated while the
⑨
device is idle. And use to (2) move to Sub Display from Main Display.
Refer to 6-1-2. Sub Display for more detailed information.
Use to start operation at the set chamber temperature. PRE-HEAT LED blinks
⑩
during the setting and is kept on when the setting is completed.
Technical Support : +82-2-3452-8966 / techsupport@ihanil.com
②
③
④
⑨
Up
Down
⑤
⑥
⑦
⑩
⑧
15/29
Advertisement
Table of Contents
