Geely GEOMETRY C 2023 Owner's Manual page 81

Safe travel
The special fixing interface specified in ISO
is at the gap between the seat cushion and
the seat back of two rear seats. Use the
fixed interface to install the child restraint
system with standard ISO specification on
the rear seat. It is not necessary to fix the
child restraint system with a seat belt at this
time. Please follow the manufacturer's
instructions when installing and using child
restraint systems, otherwise the protection
effect may be affected.
It is necessary to confirm with the
child restraint manufacturer whether
the child restraint can be used in this vehicle
type.
Install a child safety seat that requires a top
tension strap according to the following
procedures:
1.
Lower the headrest to the lowest
position;
2.
Confirm the position of ISOFIX fixed
interface;
3.
Align the ISOFIX interface of the child
restraint system with the corresponding
ISOFIX fixed interface behind the seat,
and then insert it;
4. Check whether the latch is locked
correctly;
5.
Latch the
connector.
Make sure that the top tension strap is
firmly fastened, and push and pull the
child restraint system in different directions
to check whether it is fixed. It must be
installed according
provided by the manufacturer.
If the child restraint system is not
installed to the ISOFIX fixed interface
in the correct way, the child restraint system
may not be used normally, causing serious
casualties to children. When mounting a
child restraint, be sure to strictly follow the
restraint manufacturer's instructions.
Child restraint
designed to carry loads imposed by properly
installed child
78
latch on the retaining
to the instructions
anchorages are
restraints. Under
only
no