Geely GEOMETRY C 2023 Owner's Manual page 100

When the inter-vehicle interval is near.
HUD displays different inter-vehicle
intervals via different distance cells.
When ACC detects a vehicle ahead, the
ACC status indicator will be displayed in the
area 1 shown in the figure.
The area 2 in the figure shows the set speed
of the ACC system.
The area 3 in the figure shows the vehicle
pattern.
The number of cells at the area 4 in the
figure shows the set inter-vehicle interval
between the vehicle and the preceding
vehicle.
In any case, the driver must keep
sufficient braking distance from the
preceding vehicle, and be aware of relevant
requirements of
regulations on the minimum distance or the
shortest time. It is the driver's responsibility
to abide by the law.
Use the ACC speed control
Acceleration when using ACC system
The acceleration can be realized through
either of the two methods:
Depress the accelerator pedal for active
•
acceleration.
acceleration, the driver takes control of
vehicle, and the instrument cluster shows
the active vehicle acceleration. After the
driver releases the accelerator pedal, the
ACC system continues to control the
vehicle to cruise.
If the cruise control system is already
•
enabled, to slightly accelerate, push the
speed adjustment and setting button.
Push up and release once, the vehicle
speed will increase by 1 km/h; For a long
push, the vehicle speed will keep
increasing at 5 km/h until the button is
released. The set speed maximum is 150
km/h.
Overtaking assist mode
In cruise mode,
preceding vehicle and turning on the left
turn signal lamp, the ACC accelerates/
decelerates the vehicle before it reaches the
overtaking lane to assist the driver overtake
or change the lane, until the vehicle finishes
changing the lane or turns off the left turn
signal lamp.
To enable the overtaking assist mode, the
following conditions must be met at least:
There must be a target vehicle ahead.
•
97
Starting and driving
local highway traffic
In case of active
when following the
1
2
3
4
5
6
7
8