Geely GEOMETRY C 2023 Owner's Manual page 167

Repair and maintenance
Replacement of front windshield
wiper blades
1.
The vehicle is stationary, and after the
power supply of the whole vehicle is
switched to the OFF gear, the wiper
switch position is switched from the OFF
gear to low speed or intermittent brush
gear and kept for about 2 seconds, and
the function of wiper maintenance mode
starts;
The front wiper will return to its
original position when the front wiper/
front windshield is washed or the rain
sensor is activated.
2.
Pull the windshield wiper blade away
from the windshield;
When the windshield wiper blade is
upright, the front engine hood shall
not be opened, otherwise the windshield
wiper blade or the front engine hood will be
damaged.
3. While pressing the clip of the wiper
blade, pull the wiper blade in the
direction of the arrow to release it from
the wiper arm;
4.
Remove the wiper blade;
When front windshield wiper blade is
not mounted, the windshield will be
damaged if the wiper arm gets in touch with
the windshield. Any damages caused
thereof will not be covered by vehicle
warranty.
5.
Install wiper
sequence of Step 2 to 4;
6. Set the vehicle power supply to ON and
exit the wiper maintenance mode;
7.
Switch wiper
arbitrary gear and the wiper resets.
Replacement of rear windshield
wiper blade
1. Pull the rear windshield wiper blade
away from the rear windshield;
2.
Pull the rear windshield wiper blade in
the direction of the arrow and remove it
directly;
3.
Install rear windshield wiper blade in
reversed sequence of step 1 to 2.
164
blades in reversed
adjustment knob to