Geely GEOMETRY C 2023 Owner's Manual page 150

6.
Turn the jack handle clockwise as
shown in the figure to lift the vehicle to a
sufficient height above the ground to
install the spare tire;
7.
Remove all wheel nuts;
8.
Remove the flat tire;
9. Remove rust or dirt on wheel bolts,
mounting surface and spare wheel;
Rust or dirt on wheel or connecting
position of wheel will make wheel nuts
become loose after being used for certain
time. Wheels may fall off and result in
accident. Before replacing the wheel, use a
scraper or wire brush to remove any rust or
dirt from the connection between the wheel
and the vehicle.
10.
Mount a spare tire;
11. Screw each nut clockwise with a wheel
wrench until the wheel is fixed on the
hub;
12.
Turn handle
counterclockwise to lower the vehicle.
Lower the jack completely;
Do not use grease on the bolts or
wheel nuts, otherwise the wheel nuts
of the jack
147
will become loose and the wheels of the
vehicle may fall off, causing accidents.
13.
Pre-tighten the wheel nuts in a cross
sequence as shown in the figure;
14. Lower the jack to the bottom, and take
out the jack from below the vehicle;
15. Tighten the wheel nuts with the wheel
wrench;
16.
Install the wheel nut trim cap;
17.
If necessary, install the hub trim cover.
If the front tire fails, and a spare tire
needs to be used, please be sure not
to replace the front tire with the spare tire.
For driving safety, please replace the faulty
front tire with a normal rear tire, and then
install the spare tire to the removed rear tire
position.
Storing the spare tire and tool kit
Place the spare tire with the inner side
facing up in the spare tire compartment of
the trunk, place the audio device, screw in
the lock knob and fully tighten it. Put the jack
and other tools back into the driver's tool kit,
then place the kit in the boot and secure it
properly.
Emergency
1
2
3
4
5
6
7
8