Voltech AT3600 User Manual page 260

E M
XECUTE ODE
2.
When the serial number option is enabled, after the measurements for each
transformer have been completed, the following display will be seen (with the fourth
line indicating 'Pass', 'Fail' or 'Stop' as appropriate):
If the next serial to be used simply follows on in sequence after the previous one, then
press the LAST + 1 soft-key (or the footswitch). This will enter the next serial
number automatically and return the display to the RUN-FINISH selection.
Note:
Alternatively, if the next serial number does not follow from the previous one in
sequence, you may use the keyboard (or the barcode reader) to type in a new number.
After typing, the display will be:
After typing the new number, press the ENTER key, the ENTER soft-key or the
footswitch to return to the RUN finish display.
(Again cursor soft-keys ( ← → ) appear in context, and may be used with the
backspace key (←) to correct mistakes.)
P 6.3.10.
AGE
S N E
ERIAL UMBER
LAST+1 will be displayed only if the serial number is of the form:
xxxAnnnn
where 'xxx' is a field containing any characters, A is a non-numeric
character, and 'nnnn' is a field of all numeric characters.
Both 'xxx' and 'nnnn' can be of any length, provided that the total serial
number is not more than 20 characters.
When 'nnnn' is all 9's (for example 99), the next number will show 'nnnn'
as all 0's (for example 00); the characters 'xxxA' will not be changed).
VPN 98 - 024
F
NTRY AFTER THE
V AT3600 U
OLTECH
T
IRST RANSFORMER
F P
RONT ANEL
M
SER ANUAL
O
PERATION