Table of Contents
Advertisement
7700 MultiFrame Manual
7736CD2 Dual Composite Decoder
8.
ON SCREEN MENUS
8.1.
NAVIGATING THE ON SCREEN MENU SYSTEM
A toggle switch and pushbutton allows card edge navigation of a set of On-Screen menus used to
configure the card. On-Screen menus are available only on the MONITOR output for the 7736CD2 series
of cards to ensure that On-Screen menus are not accidentally put on-air.
To enter the On-Screen menu system, press the pushbutton once. This will bring you to the main setup
menu where you can use the toggle switch to move up and down the list of available sub-menus. An arrow
(>) moves up and down the left hand side of the menu items to indicate which item you are currently
choosing. Once the arrow is on the desired item, press the pushbutton to select the next menu level.
On all menus, there are two extra selectable items: Back and Exit. Selecting Back will take you to the
previous menu (the one that was used to get into the current menu) while Exit will return the display to its
normal operating mode. On the main menu, BACK and EXIT will both take you to the normal operating
mode.
Once in a sub-menu, there may be another menu layer, or there may be a list of parameters to adjust. If
there is another set of menu options, use the toggle switch to select the desired menu item and press the
pushbutton.
To adjust any parameter, use the toggle switch to move up or down to the desired parameter and press
the pushbutton. The arrow will move to the right hand side of the line (<) indicating that you can now
adjust the parameter. Using the toggle switch, adjust the parameter to its desired value. If the parameter
is a numerical value, the number will increase if you lift the toggle switch and decrease if you push down
on the toggle switch. If the parameter contains a list of options, you can cycle through the list by pressing
the toggle switch in either direction.
When you have stopped at the desired value, depress the pushbutton. This will update the parameter to
the selected value and move the arrow back to the left side of the parameter list (>). Continue selecting
and adjusting other parameters or use the BACK or EXIT commands.
8.2.
ON SCREEN DISPLAY – MAIN MENU
Channel 1
Channel 2
Genlock
Utilities
Video 1 =
Video 2 =
Genlock =
Page - 16
Configuration of the parameters associated with channel 1 video and audio.
Configuration of the parameters associated with channel 2 video and audio.
Configures genlocking items that are shared between channels.
Card preset management, upgrading and various debug and maintenance
features.
Status of channel 1.
Status of channel 2.
Status of genlock input.
Revision 1.0.4
Advertisement
Table of Contents
