Figure 14- Configure Timer Settings - NTI ENVIROMUX Series Installation And Operation Manual

NTI Power Remote Rebooter with C13 Connection
IP Device Settings Description
(continued)
Retries Enter the number of times an IP address should be pinged before it is considered unresponsive
Unresponsive Action Choose whether the Trigger will be Latching (continuous) or Cycling (active for the configured cycle
duration)
state(response or no response) is determined in output settings.
Note: Selecting Cycling Trigger may not actually trigger the Output Relay if the Output Relay
Logical function is set to "AND". See Figure 11: Output Control Settings.
Length of time in seconds the a trigger cycle will be in effect (applies only to Cycling Trigger)
Cycle Duration
Re-Ping Wait time Length of time in seconds to wait before repeating the ping sequence after a trigger cycle (applies only
to Cycling Trigger)
Cycle Count Select how many times to cycle a trigger before automatically disabling the Ping. (A setting of 0 will
cycle the ping until a response it finally received.) (applies only to Cycling Trigger)
Two timers can be configured to trigger when the outputs will be turned ON/OFF or be rendered ACTIVE/INACTIVE. Click "Edit"
to open Configure Timer page.
Configure Timer Description
Name Enter a name for the timer
Trigger Start Schedule Select which days of the week the timer will be in effect.
When "Once" is selected, the days of the week in the Trigger Stop Schedule are disabled and the
Trigger Start Date is enabled
Trigger Start Date
Enter the start date (in the system-selected format)- only active when "Once" is checked in the Trigger
Start Schedule
Trigger Start time Enter the time of the day in hh:mm format for the trigger to be effective, select AM or PM
Trigger Stop Schedule Enter the days of the week the timer should not be in effect
When "None" is checked, Trigger Stop Date and Trigger Stop Time are disabled.
Note: "None" is only available if the Trigger Start Schedule has "Once" selected.
Trigger Stop Date Enter the date the trigger should stop altogether
Trigger Stop Time Enter the time of day in hh:mm format that the trigger should stop
After making changes, be sure to click "Save".
A Latching trigger will remain triggered until IP device state changes. Note: Triggered
A Cycling Trigger only triggers for the specified duration and returns to normal

Figure 14- Configure Timer Settings

13