Pop-Up Messages; Figure 20- Pop-Up For Switching To Manual Trigger - NTI ENVIROMUX Series Installation And Operation Manual

NTI Power Remote Rebooter with C13 Connection

Pop-Up Messages

Under Administration Pages, System Settings, you have the option to disable pop-up messages. These messages will remind
you of the consequences of certain actions you might take in the course of controlling the behavior of the Rebooter.
If you are on the Outputs page, and the Trigger Type is set to "Auto", if you click "Manual" to manually change the state, a pop-
up message will appear for you to acknowledge or cancel the action.

Figure 20- Pop-up for switching to manual trigger

If you are in Device Settings, and you change the Unresponsive Action from "Latching Trigger" to "Cycling Trigger", a pop-up
message will warn you that the output logic setting (OR or AND) may mask the cycling operation of the output.
If you change this to Cycling
Trigger, this message will pop up.
20
If you click "Manual", this
message will pop up.