Outputs; Figure 11- Output Control Settings - NTI ENVIROMUX Series Installation And Operation Manual

NTI Power Remote Rebooter with C13 Connection

Outputs

Output Control Settings Description
Name Enter the name you would like to be applied to the output
Output Control Choose whether you want the output to be controlled manually, or automatically by configured trigger
sources
Default State Choose if the power up state of the PWR-RMT-RBT-C13 should be with the output powered ON or
OFF
Cycle Duration Specify the output power cycle length in seconds; range is 1-255 ; This is the period of time before the
power outlet will be live when the outlet state is cycled.
Digital Input (#1 and #2) Place checkmark if Digital Input state is desired to be a trigger source
Add a checkmark to "Invert input trigger state" to change the trigger state:
IP Device (#1 and #2) Place checkmark if the IP Device state is desired to be a trigger source
Add a checkmark to "Invert input trigger state" to change the trigger state:
Timer (#1 and #2) Place checkmark if the configured timer is desired to be a trigger source
Add a checkmark to "Invert input trigger state" to change the trigger state:
Logical Function Set the logical function to OR or AND
INACTIVE
INACTIVE

Figure 11- Output Control Settings

No checkmark = Input will trigger when contacts are closed/low
With checkmark = Input will trigger when contacts are open/high
No checkmark = IP Device will trigger when the device is not responding to a ping
With checkmark = IP Device will trigger when the device is responding to a ping
No checkmark = A timer will trigger when a timer is scheduled to run
With checkmark = A timer will trigger when there is no timer running
OR = if any triggers are in a TRUE state, the output will be ON/ ACTIVE, otherwise it will be OFF/
AND = if all triggers are in a TRUE state, the output will be ON/ ACTIVE, otherwise it will be OFF/
11