Solution 16i
Installation Manual
methods should be performed using your finger tips to
prevent damage to the standoff. (Standoffs and screws
are supplied with each module).
All compatible add on modules will mount on these
spaces. See below for list if modules which can be added
to the Solution 16i control panel.
Module
Control Panel
Solution 16i
CM704B Zone Expander
CM710B Output Expander
CM720B LAN Power Supply
CM195 RF Receiver Expander
Table 1: Expansion Options
Use the above table to help determine which size cabinet
you will require for the job.
On some export models, one module space will not be
available as the mains transformer mounts in this location.
I N S TA L L I N G PA N E L S A N D M O D U L E S
Once the enclosure is secured in place, install the panels
and modules onto the mounting clip using the supplied
3mm screws. Do not over tighten the screws.
When fitting panels or large modules, you should use 5
mounting clips, one in each corner of the PCB and one
in the middle of the PCB underneath the main terminal
blocks. When mounting small modules, only 4 clips are
required, 1 in each corner.
Both enclosures are supplied with tamper switches,
tamper leads, tamper brackets and a quantity of
mounting clips and screws.
mounting clips and screws may be purchased in bags of
50 clips (10 packs x 5pcs). (P/N: MW890)
The supplied mounting clips are designed to use the
i
3mm machine screws supplied with the enclosure.
Note
The use of self tapping screws will damage the clips.
2-2
Installing the Hardware
Space Occupied
2 Module Spaces
1 Module Space
1 Module Space
1 Module Space
1 Module Space
If required, additional
C
B
A
A
CABLE ENTRY (REAR)
D
A
B
A
A = PCB Mounting Clip Holes
B
= Enclosure Mounting Holes
C
= Tamper Bracket Mounting Holes
D
= Earth Stud - 4mm
Figure 3: MW700 - Small Enclosure Details
Figure 3: PCB Mounting Clip
The following example shows the MW700 -Small enclosure
configured using 4 small modules.
320 mm
C
A
A
A
A A
A
A
A
A
A
A
A
Bosch Security Systems 09/11 BLCC500I
B
B