Bosch Solution 16i Installation Manual page 47

R F R A D I O K E Y F O B S
Radio Keyfobs can be used as an alternate method for
users to turn an area(s) on and off and or control an
automatic door or gate.
This section outlines how to add and delete RF keyfobs
for users. The RF Keyfob must be compatible with the RF
Receiver that has been installed by your security company.
Access > RF Keyfob >
Add Keyfob
This menu allows a master user or Installer to program or
learn a keyfob ID number into the system.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [1] + [3] + [0] + [OK].
The keypad will display the Ur = prompt.
3) Enter the user number you want to add the keyfob
to, then press [OK].
The keypad will prompt you to enter the RF keyfob ID
number.
4) Enter the RF Keyfob's ID Number or alternatively
press any button on the keyfob to automatically
learn the ID number.
Access > RF Keyfob >
Delete Keyfob
This menu allows a master user or Installer to delete the RF
keyfob that has been assigned to a user.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [1] + [3] + [1] + [OK].
The keypad will display the Ur = prompt.
3) Enter the user number who's keyfob you want to
delete, then press [OK].
Bosch Security Systems 09/11 BLCC500I
AddFOb
-
MENU 1-3-0
 
Ur=
Ent id
dELFOb
-
MENU 1-3-1
 
Ur=
dEL?
Solution 16i
Installation Manual

4) Press [OK] to delete the RF keyfob and exit.
Access > RF Keyfob >
Test Keyfob
This menu allows the installer to test the RF Keyfob
operation. Key the transmitter a number of times and the
display will show the number of transmissions received
and a signal level of GOOD, BAD or AVERAGE.
1) Enter your Installer PIN + [MENU].
2) Enter [1] + [3] + [2] = [OK] and then enter the user
number who's keyfob you want to test, then press
[OK].
3) Press any key on the transmitter you wish to test.
4) If the system receives a signal from the RF keyfob,
the keypad will display the signal strength (eg.
Average, Good or Move).
5) Repeat step 2 as required and then Press [OK] to
exit.
U S E R P R O P E R T I E S
This section outlines user properties including User Name,
Area Assignment, User Options, Erase User and Access
Group.
Access > User Properties >
User Name
This menu allows the master user or installer to program
the user's name. A maximum of 16 characters can be
entered in this field. Use the [←] and [→] keys to scroll
the cursor left and right to view the entire user name.
The text programming procedure is very similar to that of
most mobile phones. Refer the Programming Text section
on page 4-2 for more details.
User names are stored with associated events in the
system's history log. This enables accurate auditing of
user movements at a later time if required. Names are
also used when reporting alarms and arm /disarm events
in SMS and other text based reporting formats.
Access Programming

L132
MENU 1-3-2

Ur=
triger
AvErAg
UrnAME
-
MENU 1-4-0
 
5-5