Expansion Module Configuration; Eol Resistor Colour Code; Table 10: Lan Module Addressing; Table 11: Eol Resistor Colour Codes - Bosch Solution 16i Installation Manual

In addition to voice reporting, the CM101B also provides
voice prompting during remote control of the system with
full user PIN authentication. Areas and or Outputs can be
armed or turned on and off using a mobile phone or any
other telephone keypad capable of sending DTMF tones.
E X PA N S I O N M O D U L E CO N F I G U R AT I O N
LAN module support for the Solution 16i panel requires
that each module type is set to address 1. For example if a
system has 1 x CM704B and 1 x CM720B installed, they
should both be addressed as "module 1".
The panel will only look for new devices following a power
cycle and only if the LAN is not secured. To add new
devices, make sure the LAN is unsecured before powering
the system down.
Set the module Address DIP switches accordingly and
complete wiring as per instuctions. Once complete re-
power the system. To interrogate devices connected to
the LAN you can use LAN Status command, MENU-6-0-0
L AN MODUL E A DD R ES SIN G
Module SW 1
CM704B OFF
CM720B OFF
CM710B OFF
Each different module type should be
configured to address 1.

Table 10: LAN Module Addressing

Bosch Security Systems 09/11 BLCC500I
SW 2 SW 3 Address
OFF OFF 1
OFF OFF 1
OFF OFF 1
Solution 16i
Installation Manual

E O L R E S I S TO R CO LO U R CO D E
3K3 =
6K8 =

Figure 19: EOL Resistor Colour Chart

Selected Resistor Colour Codes
Value Band 1
2K2 RED
4K7 YELLOW
5K6 GREEN
8K1 GREY
10K BROWN
12K BROWN
22K RED

Table 11: EOL Resistor Colour Codes

Because of variations in the colours used to mark resistors
it is recommended that you use a multimeter to verify the
value of resistors rather than rely on the colour code.
» » E N D
Installing the Hardware

Orange
Blue
Band 2 Band 3 Band 4
RED RED BROWN
VIOLET RED BROWN
BLUE RED BROWN
BROWN RED BROWN
BLACK ORANGE BROWN
RED ORANGE BROWN
RED ORANGE BROWN
O F S E C T I O N « «
2-11