Installing Panels And Modules - Bosch Solution 16plus Installation Manual

Solution 16
plus Installation Manual

Module
Control Panel
Solution 16
plus
CM104 Zone Expander
CM110 Output Expander
CM120 LAN Power Supply
CM195 RF Receiver Expander
Table 1: Expansion Options
Use the above table to help determine which size cabinet you
will require for the job.
On some export models, one module space will not be available
as the mains transformer mounts in this location.
I NSTALLING PA NE LS AND MOD UL ES
Once the enclosure is secured in place, install the panels and
modules onto the mounting clip using the supplied 3mm
screws. Do not over tighten the screws.
When fitting panels or large modules, you should use 5
mounting clips, one in each corner of the PCB and one in the
middle of the PCB underneath the main terminal blocks. When
mounting small modules, only 4 clips are required, 1 in each
corner.
Both enclosures are supplied with tamper switches,
tamper leads, tamper
mounting clips and screws. If required, additional mounting
clips and screws may be purchased in bags of 50 clips (10 packs
x 5pcs). (P/N: MW890)
i
The supplied mounting clips are designed to use the 3mm
machine screws supplied with the enclosure. The use of self
tapping screws will damage the clips.
Note
2-2
Installing the Hardware

Space Occupied
2 Module Spaces
1 Module Space
1 Module Space
1 Module Space
1 Module Space
brackets and a quantity
C
B
A
A
D
A
B
A
A = PCB Mounting Clip Holes
B = Enclosure Mounting Holes
C
= Tamper Bracket Mounting Holes
D
= Earth Stud - 4mm
Figure 3: MW700 - Small Enclosure Details
of
Figure 4: PCB Mounting Clip
The following example shows the MW700 -Small enclosure
configured using 4 small modules.
320 mm
C
A A
A A
CABLE ENTRY (REAR)
A A
A A
Bosch Security Systems 05/10 BLCC100I
B
A
A
A
A
B