Bosch Solution 16i Installation Manual page 88

Solution 16i
Installation Manual

Display Missing Output Device
This option allows the panel to display a trouble
condition when it detects that the output device is
missing. The trouble condition will clear when the
output device has been restored.
Report Missing Output Device
This option causes the panel to send an Output Trouble
report when it detects that the output device is missing.
A restore report will be sent when the when the output
device is reconnected.
Alarm When Missing Output Device
This option causes the panel to sound an alarm when the
output device becomes missing.
Block If Armed All On
This option prevents the output from turning on when
the corresponding area is turned All On. When the area
is off, Part On or Part 2 On, the output can again operate
when the output event occurs.
Display Output Status On Keypad
This option allows the keypad to display the output that
is currently active on the keypad.
Outputs > Properties >
Macro Group
Reserved
O U T P U T T E S T I N G
Outputs > Testing >
External Siren Test
This menu allows you to test the external sirens
which have been
The test will last for 5 seconds.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [4] + [9] + [0] + [OK].
If your system has been configured to have more than
one area, the keypad will display the A = prompt.
3) Enter the Area number in which to test the external
sirens in and then press [OK].

ALARM
The keypad will display 'Siren' and the alarm icon
8-10
Output Programming

L416
MENU 4-1-6

L490
-
MENU 4-9-0
 
connected to the
A=
Siren
during the audible 3 second siren test.
Outputs > Testing >
Internal Bell Test
This menu allows you to test any internal sirens which
have been connected to the system. The test will last for
3 seconds.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [4] + [9] + [1] + [OK].
If your system has been configured to have more than
one area, the keypad will display the A = prompt.
3) Enter the Area number in which to test the internal
sirens in and then press [OK].
The keypad will display 'Bell' and the alarm icon during
the audible 3 second internal siren test.
Outputs > Testing >
Strobe Siren Test
This menu allows you to test the external strobe lights
fitted to the system. The test will last for 1 minute.
system.
1) Enter your Installer PIN or Master PIN + [MENU]
2) Enter [4] + [9] + [2] + [OK].
If your system has been configured to have more than
one area, the keypad will display the A = prompt.
3) Enter the area number in which to test the strobe
lights in and then press [OK].
During the 60 second strobe test, the keyapd will
display both the word 'Strobe' and also the alarm icon.
-
MENU 4-9-1
 
A=
BELL

ALARM
-
MENU 4-9-2
 
A=
StrObe

ALARM
Bosch Security Systems 09/11 BLCC500I
L491
L492