Main Tab; Regulators - NXP Semiconductors KITFS23LDOEVM User Manual

UM11879
NXP Semiconductors
KITFS23LDOEVM evaluation board

6.5.6.5 Main Tab

The Main Tab allows the user to monitor Events occurrence, to operate the Device States, and to configure
FS2300 functions such as Timers, PWMs, or Long Duration Timer (LDT).
• General Flags: To monitor occurrence of events on FS2300 functions.
• Device State: To monitor the device's state and request mode change.
• Timers Config: To enable timers and configure timer parameters.
• PWMs Config: To enable PWMs and configure PWMs parameters.
• LDT Config: To enable, configure, and monitor the LDT.
• Miscellaneous Management: To operate FS2300 external events and FS2300 VBOS, time slots attribution,
and interrupt settings.
Figure 70. Main Tab

6.5.6.6 Regulators

The Regulators tab allows the user to control and read status related to HVLDO1 (V1), HVLDO2 (V2), and
HVLDO3 (V3).
The Regulators tab gives access to the real-time status of each regulator for monitoring, and allows the user to
control regulators' enablement in specific modes.
• Regulators Control: To control regulators' enablement in Normal and LPON modes.
• Regulators Real-Time Status: To monitor regulators in real time.
UM11879 All information provided in this document is subject to legal disclaimers. © 2023 NXP B.V. All rights reserved.
User manual Rev. 2 — 25 September 2023
46 / 73