Table of Contents
Advertisement
NXP Semiconductors
• I/O Wake-up Config: To set I/O Wake-Up parameters when the Wake-Up feature is enabled on I/O.
• Cyclic Sense: To enable Cyclic Sense feature, to set Cyclic Sense parameters on I/Os and High-Side pins,
and to operate the Cyclic Sensing by monitoring status.
Figure 76. General I/Os
6.5.6.10 Physical Layers menu
The Physical Layers tab allows the user to configure the CAN and LIN transceivers and monitor status.
• CAN Config/Status: To configure the CAN transceiver and the monitor status. The CAN setting on the MCU
side and the CAN frames sending is done using
• LIN Config/Status: To configure the LIN transceiver and the monitor status. The LIN setting on the MCU side
and the LIN frames sending is done using
Figure 77. Physical Layers menu
UM11879
User manual
CAN
tool.
LIN
tool.
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 25 September 2023
UM11879
KITFS23LDOEVM evaluation board
© 2023 NXP B.V. All rights reserved.
50 / 73
Advertisement
Table of Contents
