Table of Contents
Advertisement
NXP Semiconductors
6 FS23 NXP GUI
This section gives guidance on use of the FS23 NXP GUI.
6.1 NXP GUI framework window
The Framework window consists of the following sections:
• Connection toolbar: Used to start communication with device, enter or exit Test/OTP modes, fix I
2
frequency and I
C main address, enable Watchdog.
• Framework settings: Manages file import/export and Framework configuration.
• Window log: Reports USB and Device communication events.
• USB and Device status: Indicates if USB or Device is connected or disconnected, shows communication
2
protocol (I
C or SPI), shows firmware and GUI version, displays current Device mode.
• Tools access bar: Provides quick access to the FS23 evaluation tools and features.
Note: Power tool is unavailable.
• Tab content: Shows the content of each tool or tab. There may be several tabs, boxes, or windows inside.
Figure 21. Framework window
If Log window, Tools access bar, or Connection toolbar do not appear on the screen, right-click on the
Framework settings bar. This action displays three selection boxes (checked if display is active):
• Log window
• Tabs corresponds to the Tools access bar
• Connection toolbar
Figure 22. Framework settings bar
UM11879
User manual
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 25 September 2023
UM11879
KITFS23LDOEVM evaluation board
© 2023 NXP B.V. All rights reserved.
2
C/SPI
24 / 73
Advertisement
Table of Contents
