Table of Contents
Advertisement
NXP Semiconductors
6.3.3.2 Watchdog configuration on MCU side
On the S32K144 MCU side, actions are configured with the Watchdog management boxes in the Connection
toolbar menu.
Figure 39. Enable Watchdog Refresh
The mechanism is fully operative when both SBC and MCU actions are enabled and have matching
configurations.
The steps for Watchdog enablement are described in
Figure 40. Watchdog enablement
1. Select Watchdog period via the Period selection box in the Connection toolbar.
2. Enable Watchdog Refresh by checking the corresponding box to enable Watchdog monitoring on the MCU
side.
3. A message is displayed in the Log window with the selected period and type values.
If the Period selection box is unavailable, verify that Enable Watchdog Refresh is unchecked.
Figure 41. Enable Watchdog Refresh
6.4 USB and Device status bar
The USB and Device status bar is at the bottom of the Framework window. This toolbar gives information on the
GUI and firmware version, on the USB connection status, and on FS23 active modes.
Figure 42. USB and Device status bar
UM11879
User manual
Figure
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 25 September 2023
KITFS23LDOEVM evaluation board
40:
UM11879
© 2023 NXP B.V. All rights reserved.
31 / 73
Advertisement
Table of Contents
