Table of Contents
Advertisement
UM11879
NXP Semiconductors
KITFS23LDOEVM evaluation board
Figure 88. ACCESS tool
Note: If FS0B and LIMP0 cannot be released after resetting the fault error counter, check that no interrupt is
still pending and triggering FS0B or LIMP0 assertion.
7.6 OTP and Mirror registers
The device incorporates one OTP block for configuration. The OTP block is shared for main parameters and
fail-safe parameters. Two sectors, S1 and S1bis, are available for the OTP block so the device can be fused
twice. The OTP configuration scheme is shown in
Figure
89.
UM11879
All information provided in this document is subject to legal disclaimers.
© 2023 NXP B.V. All rights reserved.
User manual
Rev. 2 — 25 September 2023
61 / 73
Advertisement
Table of Contents
