Set Dst; Debug; Debug Device - HIKVISION iDS-TCV500-B(I)/IM User Manual

Tyre and axle recognition unit

Table of Contents

SDK

If the remote host has been set for the device, select it to synchronize time via the remote

host.

ONVIF

Select it to synchronize time via the third-party device.

Select it to disable time synchronization.

All

Select it, and you can select any mode above.

Note

The time synchronization modes vary with different models. The actual device prevails.

4. Click Save.

13.7 Set DST

If the region where the device is located adopts Daylight Saving Time (DST), you can set this

function.

Steps

1. Go to Configuration → System → System Settings → DST.

2. Check Enable DST.

3. Set Start Time, End Time, and DST Bias.

4. Click Save.

Note

The debug configurations below are only provided to debug the device by the professionals.

You can enable the functions to debug the device.

Steps

1. Go to Configuration → Capture → Advanced → System Service.

2. Check the debug information according to your needs.

Enable Algorithm POS Information Debug

Tyre and Axle Recognition Unit User Manual

Table of Contents