Table of Contents
Advertisement
4. Click Save.
3.2.2 Set Supplement Light Parameters
Supplement light can enhance the image stabilization and adjust the brightness and color
temperature.
Steps
1. Go to Configuration → Capture → Capture Parameters → Supplement Light Parameters.
2. Select the I/O and set the supplement light parameters.
Output in Advance
It is used to adjust time difference between device pulsing and supplement light discharging,
which will improve light effect in capture.
Output Dwell Time
Light flashing duration.
Effective Status
Choose according to actual status.
High/Low
The light will flash when the level signal is high or low.
Pulse
The light will flash when there is pulse signal.
Light Compensation Mode
Please check Checkpoint or Violation Action according to actual needs.
3. Set the supplement light control mode.
– Select Default to disable the supplement light.
Tyre and Axle Recognition Unit User Manual
Figure 3-3 Set Supplement Light Parameters
7
Advertisement
Table of Contents
