Network Traffic Camera (Multi-lens LPR Camera) User Manual
11.7 Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
function.
Steps
1. Go to Configuration → Device Configuration → System Configuration → DST .
2. Check Enable DST.
3. Set Start Time, End Time, and DST Bias.
4. Click Save.
11.8 Debug
Note
The debug configurations below are only provided to debug the device by the professionals.
11.8.1 Enable Information Overlay
You can overlay the algorithm POS information on the captured pictures or playback images.
Steps
1. Go to Configuration → Device Configuration → Advanced Settings → System Service .
2. Check the debug information according to your needs.
Enable Algorithm POS Information Debug
The algorithm POS information will be overlaid on the playback image when you play back
the video with the dedicated tool.
3. Click Save.
11.8.2 Filter Capture
Set the filter capture information. The filtered conditions will not be captured.
Steps
1. Go to Configuration → Device Configuration → Advanced Settings → Capture Service .
2. Check the information to be filtered according to your needs.
Filter Checkpoint Capture of No Plate
The vehicles without license plates will not be captured.
Filter Checkpoint Capture of Same Vehicle
50